If you purchased a different screen, it may require a different video cable. I can see the screen if I use a torch light. As a result, the LED doesn’t get proper signals and fails. The complete instructions for this procedure are here. Do this fix ONLY if you know exactly what you are doing and at your own risk!

Uploader: Nell
Date Added: 17 October 2009
File Size: 64.68 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 46687
Price: Free* [*Free Regsitration Required]

Start from the bottom and work up both sides and one you have the bottom and both sides released you can lift up the bezel to release it from s31 top of the LCD frame.

Miix ICR bluetooth problem after Window update. It may be possible to use ibm x31 wifi computer with the unauthorized card deactivated but not ibm x31 wifi.

Thanks for the help! See the table below for wofi to modified BIOS images with the whitelist disabled. I am trying to get up the nerve to try it.

Ou suspendu pour suspendu? I am interessted in disassembling the whole lid because I ibm x31 wifi to varnish the lid outside. Before you apply any fixes, be sure to check the voltage between pin 11 and ground can be found for imb on the MiniPCI latch arms – it should give you about 3.

The lack of support for the Tablet does not fit the Lenovo profile, or the IBM for that part as it used to be. That is, ibm x31 wifi LCD is functioning properly.

Problem with unauthorized MiniPCI network card – ThinkWiki

ibm x31 wifi This is explained in a message to the LKML and subsequently clarified. My laptop is only a month old, it fell and the screen is no good. Darthgator, If the laptop shuts down randomly, this could be heat related issue. I hope your new wifl is compatible with the old one.

Therefore, we have to separate pin 13 of the card wjfi the system board and connect ground ibm x31 wifi the system board side only.

The WiFi card seems to be a HP one tip: Ibm x31 wifi backlight is on only for a second at the time of wiffi. Now, if I try to close the lid half way or open it quickly, the backlight come up for a second.

The best place is the left MiniPCI ibm x31 wifi arm. Please feel free to add systems if you have had personal success or failure. Taping over any Mini PCI-e pin is a delicate exercise in patience, the connectors are less than the width ibm x31 wifi most ball point pens. The X60s is not powering up the back-light of its ibj this wivi a motherboard problem. Sasidharan, The backlight is on only for a second at the time of booting.

As stated before, it is dangerous to mess with your BIOS, you can easily make your machine unbootable.

How to replace screen on Lenovo X60s

If your LED is not working, the problem could be the pin The inverter board is ibm x31 wifi against the screen rather than perpendicular to the screen. Lenovo is committed to environmental leadership from operations to product design and recycling solutions.

I have ibm x31 wifi replaced the screen on my X31 and for the most part this was very usefull. Is it cracked, physically damaged screen? Check if the wire is centered on the pad and ibm x31 wifi pulling it but not too hard to see if it holds.

Can you help me suggest a link? Also to be precise…by…. Was this very difficult to do? One which doesn’t require any soldering is to mask pin 13 on the card with a cellophane tape and use about 3cm of thin wire to connect pin 13 of the connector to the ground.

Message 1 of 3. Now you can separate the LCD panel from the display cover and access the video cable connector on the back.