For a dual port card, verify that only one port is connected to the network. Files Needed for The. Device Manager Window 4. Chapter 3 Microsoft Windows , , and XP This chapter contains instructions on how to install, update, and remove the network adapter driver on a Microsoft Windows , , or XP system. Note that your submission may not appear immediately on our site.

Uploader: Vuzuru
Date Added: 25 June 2007
File Size: 28.81 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 44176
Price: Free* [*Free Regsitration Required]

A confirmation prompt is displayed.

Page 55 Network Adapter Card Installation Guide Note If you installed a dual port network adapter card, connect only one port to the network. If your network adapter card has the switch, you must set it to reflect the active port or speed of allied telesyn at 2700fx adapter.

Do 2700fs of the following: In a properly functioning card, all tests will report PASS, with the following possible exceptions: You cannot run the utility from the Installation CD. Caution Cautions inform you that te,esyn or omitting a specific action may result in equipment damage or allied telesyn at 2700fx of data. The end of the fiber optic cable is held in the core of the ferrule in the plug.

FX | Allied Telesis

Page 26 Chapter 1: Allied telesyn at 2700fx test requires that you run AT-Diag utility on two systems. When you reach the end of the cleaning surface, pick up the ferrule tip, rotate and place it at the top and rub downwards at least 2 times.

Network Adapter Card Installation Guide Dual port adapters also simplify the task of relocating nodes in a network. Troubleshooting For a fiber optic allied telesyn at 2700fx, verify that the port on the network allied telesyn at 2700fx card and the port on the remote device are operating with the same duplex 200fx. Microsoft Windows, and XP Table Appendix E contains translated safety statements for installing this equipment.

In order to use the AT-Stat utility, you must install it on your system. Installing a Network Adapter Card 3.

Remove all metal jewelry, such as rings and watches, before installing or removing a line card from a powered-on chassis.

Allied Telesis AT-2700FX Installation Manual

Select the Allied Telesyn allieed adapter card whose driver you want to remove. The Hardware tab is shown in Figure Insert Disk Window Page Chapter Microsoft Windows Nt 4. If this resolves the problem, replace the failed cable. Power ON the system. Allied telesyn at 2700fx Adapter Card Installation Guide 3. The wizard installs the adapter driver. Page 54 Chapter 2: Comments to this Allied telesyn at 2700fx Your Name.


Adapters Tab Window 3. Promote cracked software, or other illegal content. Add or Remove Programs Telesyh If it detects a card sthe utility displays the card model name s in the ATSetup window. Translated Safety Statements Lasersicherheitshinweise Allied telesyn at 2700fx Save any changes you may have made to the unattend.

AT-Diag Utility Systems containing more than one Allied Telesyn adapter card display alled prompt similar to the following prior to displaying the main menu.

When you select the option, the utility displays a window listing the adapters in the system. If you installed the adapter card in a Microsoft Windowsallied telesyn at 2700fx, or XP system and did not pre-install the driver, the Found Allied telesyn at 2700fx Hardware Wizard launches automatically once the system detects the new card. Translated Safety Statements Warning: AT-Setup from the Installation 1.

The installation process can take up to 30 seconds to complete.